USA! Allen Amps
ALLEN AMPLIFICATION
 
   
 


The Maverick™ with patent-pending FDM™ technology puts tonal control at your fingertips. Just turn the modulator knob to adjust speaker output and amplifier interaction, helping you find that sweet spot of saturated tube tone but at a significantly lower volume. Tweak the knob for a wide range of tones: More attenuation affords a warmer tone while less attenuation restores volume and brightness.

SPECIFICATIONS
Nominal Basket Diameter
Nominal Impedance
Power Rating Watts
Resonance
Usable Frequency Range
Sensitivity***
Magnet Weight
Gap Height
Voice Coil Diameter

MOUNTING INFORMATION
Recommended Enclosure
   Sealed
   Vented
Driver Volume Displaced
Overall Diameter
Baffle Hole Diameter
Front Sealing Gasket
Rear Sealing Gasket
Mounting Holes Diameter
Mounting Holes B.C.D.
Depth
Net Weight
Shipping Weight


12", 304.8 mm
8 ohms
75W
82.45 Hz
75 Hz - 5.2 kHz
91.5 dB (No knob turn), 100 dB (Full turn)
38 oz.
0.312", 7.92 mm
1.75", 44.5 mm



N/A
Acceptable
134.25 cu.in., 2.2 liters
12.03", 305.5 mm
10.95", 278.1 mm
Yes
Yes
0.25", 6.4 mm
11.59", 294.3 mm
6.562", 166.6 mm
7.8 lbs., 3.54 kg
9.7 lbs., 4.39 kg

*** The average on axis output across the usable frequency range when applying 1W/1m into the nominal impedance, i.e. 2.83V/8, 4V/16. Eminence response curves are measured under the following conditions: All speakers are tested at 1W/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle | 2ft x 2ft baffle is built into the wall with speaker mounted flush against a steel ring for minimum diffraction | Carver PM-120 amplifier | 2700ft3 chamber with fiberglass on all six surfaces (three with custom-made wedges).